EPEVER Photo voltaic Demand CONTROLLER Set up: TRACER AN Sequence CONTROLLE
EPEVER Photo voltaic Demand CONTROLLER Set up: TRACER AN Sequence CONTROLLE
Blog Article
The EPEVER Tracer AN Sequence Photo voltaic Demand Controller is actually a remarkably efficient solar controller designed for off-grid solar techniques. Based upon multiphase synchronous rectification technologies, it assures optimized Electrical power conversion and method security for a wide array of photovoltaic (PV) purposes.
Important Characteristics with the EPEVER Tracer AN Collection Controller
The Tracer AN sequence makes use of EPEVER Photo voltaic Demand Controller know-how for top-quality photo voltaic energy harvesting. Key attributes consist of:
Multiphase Synchronous Rectification (MSR) for improved Power conversion.
Sophisticated MPPT Algorithm with >99% efficiency.
Dual-Phase Charging for Increased battery everyday living.
Liquid crystal display Display screen with real-time information monitoring.
Numerous Load Manage Modes such as manual and timer.
Comprehensive Digital Protections versus overcharging, around-discharging, small circuits, and reverse polarity.
Action-by-Action Information to Creating the EPEVER Tracer AN Sequence Controller
1. Unboxing and Getting ready the Controller
Make sure all components are included: Tracer AN device, temperature sensor, interaction cables, and consumer guide.
Confirm the model quantity and voltage ratings match your photo voltaic panel and battery technical specs.
two. Mounting the Demand Controller
Decide on a effectively-ventilated, dry area close to the battery lender.
Protected the Tracer AN controller using the supplied mounting brackets.
Maintain good clearance for warmth dissipation.
3. Wiring the Solar Demand Controller
Warning: Often adhere to proper security protocols and make sure the technique is powered off before connecting factors.
Action 1: Connect the battery terminals to your cost controller (good to positive, detrimental to adverse).
Stage two: Hook up the solar panel array towards the PV enter terminals.
Phase 3: Join the load terminals if utilizing a direct load relationship.
Action 4: Double-Test all connections for polarity and tightness.
four. Configuring the Controller Settings
Power to the controller by connecting the battery very first.
Utilize the Liquid crystal display Show to navigate the configurations menu.
Configure:
Battery Variety: AGM, GEL, Flooded, Lithium.
Charging Parameters: Absorption voltage, float voltage.
Load Manage Modes: Handbook, timer, gentle Manage.
five. Monitoring and Details Logging
The Tracer AN Sequence supports genuine-time checking using the MT50 distant meter.
Facts could be logged via the RS485 interaction port making use of software for instance Solar Station Computer system.
Distant checking is achievable with the EPEVER WiFi module.
six. Troubleshooting Typical Difficulties
Concern 1: No Ability Output
Check out battery voltage and connections.
Verify PV panel voltage exceeds battery voltage.
Situation 2: In excess of-Voltage Safety
Confirm the photo voltaic array’s voltage rating.
Change method parameters if required.
Concern three: No Battery Charging
Inspect PV Click Here wiring for continuity.
Confirm MPPT settings from the menu.
Benefits of the Tracer AN Sequence with MSR Technology
The multiphase synchronous rectification technologies assures:
Higher Effectiveness: Reduced Power losses through conversion.
Enhanced Dependability: Secure overall performance underneath variable loads.
Extended Battery Existence: Dependable and correct charging profiles.
Conclusion
The EPEVER Solar Demand Controller with multiphase synchronous rectification technology is undoubtedly an exceptional choice for optimizing solar energy technology and extending battery daily life. By following the above setup guideline, customers can guarantee maximum effectiveness and procedure longevity.